Veneer Module

Veneer modules are used over existing refractory lining where such linings are in good condition and lower heat loss with improved refractory life is desired. In most cases, when the modules are installed over dense refractory, the payback from fuel savings in a few months.

The modules are composed of strips of Fibefrax® & Insulfrax® blanket compressed together to form a block. They are installed by mortaring over hot face of properly prepared existing refractory lining surface.

 

Refer to the product Safety Data Sheet (SDS) for recommended work practices and other product safety information.

For additional information on products, properties and performance, typical applications, or to identify the recommended product for your application, see the product information sheet listed above or contact the Unifrax Application Engineering Department at +91 22 2921 2200.